BUX HF STIX

BHF75M
75 METER 3/8" X 24 THREAD 8 feet long $16.95

BHF40M 40 METER 3/8" X 24 THREAD 8 feet long
$16.95

BHF20M 20 METER 3/8" X 24 THREAD 8 feet long
$16.95

BHF17M 17 METER 3/8" X 24 THREAD 8 feet long
$16.95

BHF15M 15 METER 3/8" X 24 THREAD 8 feet long $16.95

BHF10M 10 METER 3/8" X 24 THREAD 8 feet long
$16.95

BHF6M 6 METER 3/8" X 24 THREAD 5 feet long
$16.95

These two-piece Mobile antennas consist of
a hollow fiberglass base section approximately 1/2 inch diameter with the
loading coil wound directly on the fiberglass and covered with shrink
tubing. The chrome plated brass base fitting has 3/8 inch X 24 threads
that fit the amateur standard 3/8" X 24 mobile mount.

Replacement,
48 inch Tips for above tuneable-tip antennas.
TIP48, $2.95
→
→



Trailer Hitch Mount
for antennas with 3/8" X 24 (standard) antenna base. Stainless steel
with SO239 coax fitting to receive PL259 coax connector.
Also accepts the BUX HF STIX shown above.
Stock number THM1
$ 11.95


BUX stix
HF antennas
for Mobile and Base
Applications:
Power Rated at 250 Watts P E P;
Typical 2:1.VSWR band width is:
·
75 meter: 40 KHz. 40 Meter: 60 KHz.
·
20 Meter: 150 KHz. 17 Meter: 175 KHz.
·
15 Meter: 200 KHz. 12 Meter: 300 KHz.
·
10 Meter: 500 KHz. 6 Meter: 1000 Khz.
TUNING INSTRUCTIONS:
Insert the whip into lower section ferrule about four inches (as shown at
right) and tighten set screw. Assemble with fiberglass lower section (as
shown at left). Install a VSWR meter at the transceiver and apply 10 to 25
watts of power. Adjust the VSWR meter and output frequency for lowest VSWR
reading, indicating resonance. If resonant frequency is too high,
loosen set screw and extend top whip until desired resonant frequency is
found. If resonant frequency is too low, loosen set screw and adjust
whip further into lower section. For best results,
adjustments should be made in small increments.
CAUTION: If
required, cut off the bottom of the whip to ensure it does not extend down
into the coil of the antenna. Failure to observe this precaution will
cause heat damage and void any warranty. At resonance, VSWR should be
1.5:1 or less when properly matched. When tuning is complete, tighten set
screws securely. NOTE: Bandwidth and VSWR will vary due to mounting
location. If your installation has a VSWR over 1.5:1 at resonance, or you
need to operate over a greater bandwidth a tuner may be required.


DBLSPCL (without BUX UNUN (ONION)
When
the stations with the gain and power in their antennas are transmitting in
the horizontal plane, then you should be meeting them in the same plane.
Horizontal signals tend to follow the earths contour, and are easier to
capture using a horizontally polarized antenna.
See the BUX UNUN elsewhere on this page.
By combining a
pair (two) of the single band HF Mobile (loaded) tuneable-tip antennas
above, you can have an ideal, single element, horizontal dipole (beam).
This type antenna opens the world of HF communications for the
apartment dweller, RV HAM, field-day operating, and a variety of other
uses and applications. The packages described below include two
antenna, the Double Antenna-Bracket (DBLBRKT), and mounting hardware.
$ 39.97
DBLSPCL (without
BUX UNUN (ONION)
75 Meters→
,
40 Meters→
, 20
Meters→
,
17 Meters→
, 15
Meters→
, 10
Meters→
,
6 Meters →


BUX Double Combo "with"
BUX ONION (UNUN).
By combining a pair (two) of the single band HF Mobile (loaded) tuneable-tip
antennas above, you can have an ideal, single element, horizontal dipole
(beam). This type antenna opens the world of HF communications for the
apartment dweller, RV HAM, field-day operating, and a variety of other
uses and applications. The package described here include:
two antenna, the Double-Bracket (DBLBRKT), mounting hardware, and
BUX BALUN (UNUN).
$AVE, BOTH, DPLSPCL & BUXUNUN, for only
$ 54.97,
ORDER, DBLCOMBO
75 Meters→
,
40 Meters→
,
20 Meters→
,
17 Meters→
,
15 Meters→
,
10 Meters→
6
Meters →


