- To Enter Dealer Programming Mode
- Switch Radio Off
- Hold Down the PTT Monitor and Scan
Buttons While Turning the Radio On
- Proceed to Program Radio
- When Programming is Complete
- Exit Dealer Programming Mode
- Switch Radio Off
- Hold Down the PTT, Monitor and Enter
Buttons While Turning the Radio On
Note:
- When the GP68 is in programming mode it
is still fully operation i.e transmit and receive e.t.c
- When the GP68 is in programming mode it
will not transmit or receive until you exit from dealer programming mode
Overview of the Programming Process
The following procedures assume that you have read and understood the basic
operation of of the GP68 from the GP68 User's ManuaL A Dealer's radio is the radio where
all the necessary options are programmed into. A User's radio is the radio whose options
are cloned from the Dealer's radio; it is this radio that is given to the customer. Remove
jumper R417, only if you want the radio to stay in programming mode. Do not forget to
replace jumper R417 in order to exit programming mode.
IMPORTANT
If the Dealer's radio is to be given to the customer, remember to place
R417 with a 51K resistor to disable the programming function
|